Go to Language SelectorGo to Global NavigationGo to Site SearchGo to Sub NavigationGo to ContentGo to Site Information

Hamamatsu Photonics
Home  |  Site Map  |  Inquiry  |  MyAccount
Language Selector Japanese English
Global Site

Global Navigation
Products Support Exhibition Research And Development Corporate Profile Investors
Search Search for: Search Help

Opto-
semiconductors
Photosensitive
Electron Tube
LED/LD/
Light Sources
Cameras/Image Measurement
Life Science/
Medical
Semiconductor/FPD Analysis
Optical Measurement
X-ray
Others
Products > Division > Laser Group > THz Antenna Modules > THz Antenna Modules


ここから本文です
新製品

THz Antenna Modules (Emission/Detection Module for THz Wave)


G10620


THz Antenna Modules (Emission/Detection Module for THz Wave)

G10620 series are THz electromagnetic waves emission/detection modules, in which a photoconductive antenna chip and a lens for THz electromagnetic wave are integrated. This module also has a SMA connector, which facilitates easy connection to other equipments. Alignment between the photoconductive antenna chip and the lens is factory set. A M6 tapping hole and two M2 tapping holes are prepared on faces to help easy setup.
There are three prepared design pattern of photoconductive antenna chips; Dipole: G10620-01, Bow-tie: G10620-02, and Spiral: G10620-03. When other pattern of photoconductive antenna chip is necessary, please contact HAMAMATSU sales person.


contact by E-mailLiteraturePriceQuoteOther

ページ内を移動するナビゲーションです

Specifications are subject to change without notice.

FEATURES
・  Possible  to  use  for  both  emission  and  detection
・  No  need  for  alignment  between  photoconductive  antenna  chip  and  lens
  Alignment  of  photoconductive  antenna  chip  and  lens  is  already  done  in  this  module.
・  Easy  Connection  to  other  devices
  SMA  connector  facilitates  the  connection  with  other  equipments.
APPLICATIONS
・  Nondestructive  Inspection  for  Industrial  Field,
Non-contact  Measurement  for  Biological  Tissue
・  Far-infrared  Spectroscopy
・  Material  Analysis
・  Structure  Inspection
・  Security,  etc.


Typical Pattern of Photoconductive Antenna / Schematic Figure of Photoconductive Part
Dipole:
   G10620-01
Bow-Tie:
   G10620-02
Spiral:
   G10620-03

An Example of Experimental Setup


An Example of Measured Results of Frequency Spectrum
*These data are typical measured results. Under improper
experimental conditions, the similar results cannot be obtained.

*To acquire these data, a pair of pallaboloidal mirrors are used
between emission and detection modules.

*Measurement conditions of input optical power are shown below.
G10620-01 Emitter 5 mW, Receiver 5 mW
G10620-02 Emitter 5 mW, Receiver 5 mW



ABSOLUTE MAXIMUM RATINGS

Parameter
Symbol
Value
Unit
  Maximum applied voltage
Vmax
15 *1
V
  Maximum input optical power
Pmax
15 *2, *3
mW
  Operating Temperature *4 Top(c)
+5 to +35

  Storage Temperature *4
Tstg
-20 to +40

*1 : Recommended value 10 V
*2 : Recommended value 10 mW
*3 : Use a femtosecond laser, which has repetition rate from 50 MHz to 150 MHz.
*4 : No condensation.


Dimensional Outline (Unit: mm)


*Specifications are subject to change without notice.







Hamamatsu Photonics K.K
Site Information Terms of Use Privacy Policy Help
Copyright © Hamamatsu Photonics K.K. All Rights Reserved.